|
Important:
Do not operate lift until installed!!
1.
Center lift on transom
2.
Clamp lift to transom
3.
Drill and Bolt to transom
4.
Pump installation: The pump mounts inside the boat in as
dry an area as possible. Mount the unit securely in a vertical position
with the motor up and the base of the reservoir sitting on the floor.
NOTE: It is very important that you
hold fitting on side of the cylinder and not let it turn while you are
tightening hose end on same.
5.
Connect long hydraulic hose to the bottom of the cylinder and to
up-side of pump.
6.
Connect shorter hose to top of cylinder and down-side of pump.
7.
Control switch is provided to mount on control handle of
outboard.
8.
The wiring is red to red, blue to blue, and green to green.
9.
Hook up wires of battery, red to positive and black to negative.
If overload occurs, the pump has ambient breaker, which will reset
itself automatically.
10.
Fill the reservoir with the jack plate in the down position to
the max line on the reservoir (oil is provided). Run the plate up and
down several times, then check reservoir and refill to max line again.
(The oil that we use for the hydraulic jac plate is a 20 weight non
detergent motor oil, 20w-20. You may also use a good grade light
hydraulic oil).
Note: After several hours of use or
if slide plate (bearing area) becomes dry, using the grease fittings
located on each side of the plate, give each fitting a couple of shots
of preferably waterproof marine grade grease, while the plate is being
moved up and down. Don’t over lubricate. This will probably be necessary
only once or twice every six months and make for a trouble free
operation.
|
